Please pay attention to the detail pictures for better understanding about body condition, actual unit may have minor marks / scratches and The pictures are a part of the description, Please look at all of them carefully. You will only receive what you see in the ad photos or same item with 95% similar condition. It fully tested and all functions work. Item comes with Australian type power cord only. The MXWANI8 8-Channel Audio Network Interface from Shure is designed to connect and distribute Shure's Microflex wireless system to conference room AV systems.
It is Dante network compatible and features 8 analog outputs as well as a 4-port gigabit Ethernet switch. The MXWANI8 can be controlled through either its front-panel or through a networked Mac or PC running the Microflex Wireless Control software.
The unit can provide power over Ethernet (PoE) through its first port, allowing you to power such components as the Microflex MXWAPT transceiver. You can monitor your audio via the front-panel 1/4 headphone output.
Four port gigabit switch: Optimized port configurations for connection to the Access Point Transceiver and Networked Charging Stations, third party control systems, and corporate networks. Ethernet connectivity: Send audio and control signals over long cable runs of up to 300 feet or anywhere over a corporate network. Power over Ethernet: Port 1 of the rear panel switch supplies power over Ethernet to the Access Point Transceiver for simplified installation.Corporate uplink mode: Link to the corporate network for remote control of system settings while keeping audio off the network for security and to reduce bandwidth. Front panel controls: Mute or solo channels and set input/output levels easily from the front panel. PC/Mac software control: Access the Microflex Wireless Control Software from a networked computer for input/output levels and port configuration.
Dante networking: Transports low latency digital audio received from wireless microphones over Ethernet to any other Dante-equipped device. Headphone output: Solo audio signal on any channel. Frequency Response 20 Hz to 20 kHz. Dynamic Range Analog-to-Dante: 113 dB (20 Hz to 29 kHz, A-weighted, typical). Dante-to-Analog: 110 dB (20 Hz to 29 kHz, A-weighted, typical). Output Noise Line: -84.5 dBV (20 Hz to 29 kHz, A-weighted, typical). Aux: -95.2 dBV (20 Hz to 29 kHz, A-weighted, typical). Mic: -106.5 dBV (20 Hz to 29 kHz, A-weighted, typical). Polarity Non-inverting, any input to any output.Clipping Level Line: 23.8 dBV (minimum). Aux: 10.8 dBV (minimum). Clipping Level Line: 26.2 dBV.
Headphone Output 1/4 (6.3 mm) TRS, 100 mW, 350 O, dual mono (will drive stereo phones). AD/DA Conversion 24-bit, 48 kHz. Latency Analog-to-Dante: 0.21 ms (Estimated Nominal, ±0.1 ms).
Dante-to-Analog: 0.24 ms + TN (Estimated Nominal, ±0.1 ms). TN = Network latency in milliseconds, as set in Dante Controller.Note: Dante network latency is typically associated with the receiving device. Network Interface Four-Port Gigabit Ethernet Switch, Dante digital audio.
Uplinks Port: Selectable, blocks multicast traffic (Port 4). PoE Provided on Port 1 to power MXWAPT.Cable Requirements Cat 5e or higher, shielded, 100 m maximum between network devices. Network Addressing Capability DHCP, link-local, static. Power Requirements 100 to 240 V AC, 50-60 Hz, 1 A.
Temperature Range Operating: 0 to 145°F (-18 to 63°C). Storage: -20 to 165°F (-29 to 74°C). Dimensions 1.7 x 19.0 x 14.4 (44 x 483 x 366 mm). Weight 7.1 lb (3.2 kg).
Box Dimensions (HxWxD) 2.7 x 15.6 x 22.3. This item is in the category "Musical Instruments\Pro Audio\Microphones & Wireless Systems".gadgets" and is located in this country: AU. This item can be shipped worldwide.